Parameters: 1: Dimensions: 194 * 122 * 110 (L * W * H) 2: Operating voltage: 220V current 10-11A 3: Power (adjustable): 2100W-2500W 4: Load Inductance: 100uH (BICTOR6243 + inductance meter to measure the card with a victory) 5: conversion efficiency of> 90% 6: Operating Frequency: 20-25kHZ 7: Operating temperature: -10 degrees to +50 degrees 8: Work mode: continuous heating 9: Langchong protection – + 1500V 10: Anti-clutter: 4000V 11: induction coil heating element to the mounting distance 20mm (plus the thickness of the epoxy board insulation cotton after pressing) 12: multiple sets of coils and wound in the same heating element, the mutual distance between the coils is greater than 6 cm. 13: 4 square lines, the effective length of about 12-14 meters, the inductance of just one parameter, in fact, the line current to be measured Then inductance table (Victory brand 6243) measured the input current, the rated input current is reached, if not reach it by adjusting potentiometer clockwise, when adjusting note that if the current display value becomes smaller, you can not adjust, may is the inductance excessive, the need to reduce the inductance. (Inductance is reduced, is to reduce the number of turns, the line current, increasing the number of turns.) Second, the wiring instructions 1, the three indicators for “Power Lights”, “work lights”, “trouble light” lamps. During normal operation the “Power Lights”, “work lights” in light. “Fault light” lamp. When hair circuit failure “trouble light” lamp flashes. 2, 220V power supply connected to the “take 220V AC” column, regardless of the line of fire just access to the zero line.